Filament Spool Bar Bracket

Get your filament spools up off the bench and onto the wall. Fix two brackets to the wall, drop a bar into the curved cradles and slide your spools on. The cradle takes a bar up to 29 mm across, such as a standard 1 inch wooden dowel from any hardware or DIY shop. The braced triangular profile keeps it strong while using very little material.

Small holes either side of the cradle let you tie a length of filament across the top, so the bar can't lift out. Or leave them clear and use an extra bracket in the middle of a long bar for added support.

The square end cap is a flat surface ready for a sticker, label or your own design.

Features

• Holds a bar or wooden dowel up to 29 mm (e.g. a 1 inch dowel)
• Tie-off holes - thread filament across to stop the bar escaping
• Use extra brackets mid-way along a long bar for stability
• Square end cap ready for a sticker or design
• Braced triangular design for strength
• Screw-mount to wall
• Prints without supports

Specifications

• Size: approx. 130 mm (depth) x 147 mm (height) x 30 mm wide
• Bar size: up to 29 mm diameter
• End cap: 30 x 30 mm
• Material: PETG-CF (carbon-fibre reinforced PETG - stiff, strong and won't crack under load)
• Price is per bracket - minimum order 2 (one pair per bar)
• Bar, screws and filament spools not included

Tags: filament storage, spool holder, 3d printer, wall bracket, workshop